Juno JKI9050 Manuel d'utilisateur télécharger pdf (Page 9)

Starting up - Setting the Temperature

1 Light switch

2 Temperature regulator and ON/OFF switch

The temperature regulator is located at the top of the

appliance on the control panel. It is also the ON/OFF

switch.

A coin is required to turn the temperature regulator.

This makes it more difficult to change the tempera-

ture setting accidentally (child safety).

Setting "

" = Refrigeration off

Setting "1" = Warmest interior temperature

Setting "4" = Coldest interior temperature

1. Plug the mains plug into the mains socket.

2. Set the required temperature by turning the tem-

perature regulator. The interior lighting comes on.

The compressor starts and then runs automati-

cally.

3. If you want a higher or lower temperature, turn the

temperature regulator to a warmer or cooler set-

ting respectively.

Note: When the setting is changed, the compressor

does not start immediately if automatic defrosting is

currently taking place.

Goods to be refrigerated can be loaded

immediately after switching on, because the

storage temperature in the refrigerator is

quickly reached.

Note: From a food science point of view,

+5 °C for the refrigerator compartment

should be considered cold enough as a stor-

age temperature.

The following effects are of significance in respect of

the interior temperature:

– Ambient temperature;

– Quantity and temperature of the food stored;

– Frequency with which the door is opened and

how long it is left open

– A defect in the appliance.

The temperature regulator setting may therefore

need to be adjusted to suit the specific conditions.

Recommendet settings:

Examples:

Note: At the setting given under „recommendet set-

tings“ the fridge has an average temperature of

approx. +5 °C. These figures apply at ambient tem-

peratures from +10 °Cto+38°C.

Important!

High ambient temperatures (e.g. on hot summer

days) and a cold setting on the temperature regulator

(position "4") can cause the compressor to run con-

tinuously.

Reason: when the ambient temperature is high, the

compressor must run continuously to maintain the

low temperature in the appliance. The fridge will not

be able to defrost since automatic defrosting of the

fridge is only possible when the compressor is not

running (see also "Defrosting" section). The result is

the build up of a thick layer of frost on the fridge rear

wall.

If this happens, turn the temperature regulator back

to a warmer setting (position "3"). At this setting the

compressor will be switched on and off as usual and

automatic defrosting recommenced.

Ambient

Temperature

Temperature Controller

Position

Approx. 10 °C Range up to 1

Approx. 16 °C Range about 2

Approx. 25 °C Range about 2

Approx. 32 °C2to3

Approx. 38 °C1to2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

Juno JKI9050 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Juno JKI9050