Juno JKG 7485 Manuel d'utilisateur télécharger pdf (Page 10)

PR33

20mm

8mm

PR34

Open both the appliance door and that of the kitchen

unit to approx. 90¡. Place the little plates over the

runners. Hold the doors of the appliance and the unit

together and mark the holes.

PR35

D726

Apply covers (B) on joint cover lugs and into hinge

holes.

Remove the little plates and make the holes with a

diam. of 2 mm. Replace the little platee over the

runners and screw in the screws provided (3.5x16

mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that the

doors of the appliance and the kitchen unit open

properly.

Position the runners (A) at the top and bottom of the

inside of the kitchen unit as shown in Fig. and mark

the position of the external holes.

After preparing the holes, screw the runners to the

kitchen unit door using 3.5x16 mm screws.

D265

If after having carried out the previously described

operation there is still some space between the

appliance and the kitchen unit, fit the trimming

provided together with the appliance on the stop

strip (A).

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Juno JKG 7485 Manuel d'utilisateur Page 10