Juno JCT14510S5 Manuel d'utilisateur télécharger pdf (Page 25)

maximum power is shown on the lamp

cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised

Service Centre.

INSTALLATION

WARNING! Refer to Safety

chapters.

Positioning

This appliance can be installed in a dry, well

ventilated indoor where the ambient

temperature corresponds to the climate

class indicated on the rating plate of the

appliance:

Cli-

mate

class

Ambient temperature

SN +10°C to + 32°C

N +16°C to + 32°C

ST +16°C to + 38°C

T +16°C to + 43°C

Some functional problems might

occur for some types of models

when operating outside of that

range. The correct operation

can only be guaranteed within

the specified temperature range.

If you have any doubts

regarding where to install the

appliance, please turn to the

vendor, to our customer service

or to the nearest Authorised

Service Centre.

Electrical connection

• Before plugging in, ensure that the

voltage and frequency shown on the

rating plate correspond to your domestic

power supply.

• The appliance must be earthed. The

power supply cable plug is provided with

a contact for this purpose. If the

domestic power supply socket is not

earthed, connect the appliance to a

separate earth in compliance with

current regulations, consulting a qualified

electrician.

• The manufacturer declines all

responsibility if the above safety

precautions are not observed.

• This appliance complies with the E.E.C.

Directives.

Door reversibility

1.

Loosen and remove the upper pin.

2. Remove the upper door.

3. Remove the spacer.

4. Loosen the middle hinge.

25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Commentaires sur ces manuels

Pas de commentaire